Reg. Nr. L 6790 Wet 36 van 1947 - Bush Encroachment

• Place a 20 to 30 mesh screen over filling port.
• Through the screen, fill the spray tank half full with water and start
agitation.
• If a wettable powder is used, make a slurry with the water carrier,
and add it SLOWLY through the screen into the tank. Continue
agitation.
• If a flowable formulation is used, premix one part flowable with one
part water. Add diluted mixture SLOWLY through the screen into the
tank. Continue agitation.
• If an emulsifiable concentrated formulation is used, premix one part
EC with two parts water. Add diluted mixture SLOWLY through the
screen into the tank. Continue agitation.
• Continue filling the spray tank with water and add the required amount
of ROUNDUP MAX ® at the end of the filling process.
• Add individual formulations to the spray tank as follows: Buffer
(Kynobuff/Bladbuff) and / or ammonium sulphate, wettable powder,
suspension concentrate, soluble concentrate, emulsifiable concen
trate ROUNDUP MAX ® and drift control additive.
6
• Tank mixing procedure with co-herbicides:
• Clean sprayer parts immediately after using this product by thoroughly
flushing with water.
• ROUNDUP MAX ® mixes readily with water. When sprayed alone, half fill
the mixing tank with clean good quality water. If necessary add a buffering
agent to achieve a pH of 4,5 to 6,5 for the total mix. Add the required
amount of ROUNDUP MAX ® while stirring continually. Add the remaining
water.
• Note: Always use clean, good quality water for mixing.
MIXING INSTRUCTIONS