Ercolina Catalogue - Pipe & Tube Machines LTD

NON MANDREL FORMERS
SPECIAL FORMERS FOR PROFILES
Art. series 199
NOTE: Hexagon 40 mounts on all machines
Hexagon 50 mounts only on MG76, MG030, TB60, TB050,
TB050EDT, SB48, SB060
Art.
Hexagon, mm
199/1 1
40
199/2
40
199/3 40
199/4
40
199/5 40
199/6 40
199/7 40
199/8 40
199/9 40
199/10 40
199/11 2
40
199/12 2
40
Radii, cm*
from R10 to R35
from R36 to R56
from R57 to R82
from R83 to R90
from R91 to R104
from R105 to R120
from R121 to R130
from R131 to R150
from R151 to R170
from R171 to R190
from R191 to R225
from R226 to R260
* Bending radii may be requested within above ranges for each size in mm (ex. from R10 to R35 = R10, R11, R12, ...).
1
The former may only be used with mod. MD071 and MN092. For mod. MB42 it is necessary to use the former art. 158/1
with special shaft art. 042C. In some cases it may be necessary, after the Manufacturer evaluation, the use of special former art. 042S.
2
Formers may only be used with mod. MB42 and MB42P.
Upon ordering it is necessary to indicate the bending direction (Ref. A, B, C, ...). Please refer to the following table:
PROFILE REFERENCE FOR BENDING DIRECTION
SQUARE HOLLOW
PROFILE
A
ROUND BAR SQUARE BAR
Z I
Please contact the Manufacturer for information on possible bending radii
B
C
D
E
RECTANGULAR
HOLLOW PROFILE T-PROFILE
X
M
78
FLAT BAR
F
G
U-PROFILE
SA / E / A