Service Manual Analyzer for Combi Screen® 11 SYS urine ... - Alere

More documents

Recommendations

Info

Service Manual CombiScan 100 24 7.4. Replacement of printer and panel (UCP-4452-1) Operation Figure 7.4.1. Disassemble the equipment According to 7.1.1. – 7.1.5. 7.4.2. Place the upper housing behind the lower housing. 7.4.3. Unscrew the 4 screws which fix the printer and the PCB, lift the panel. 7.4.4. Disconnect both connectors from the printer PCB. Note the directions and routing of the cables! (2p and 16p)
CombiScan 100 Service Manual Operation Figure 7.4.5. Connect the cables to the spare assembled printer panel. (2p and 16p) Figure according to point 7.4.4. 7.4.6. Place the printer panel onto its location. Screw in the two short screws (PTKA 22x6) into the front holes, then screw in the two longer screws (PTKA 22x8) onto the rear. 7.4.7. Assemble the equipment According to the 7.1.9. – 7.1.13. 25
Page 1 and 2: Service Manual Analyzer for Combi S
Page 3 and 4: State: 30.8.2006, Version: 1.2 Cont
Page 5 and 6: 2. Check of operation Connect the d
Page 7 and 8: 3. Check and repair 3.1 Check and r
Page 9 and 10: 3.3. Replacement and repair of the
Page 11 and 12: 3.5. Handling of the optics defect
Page 13 and 14: 4. Spare parts Order Article No. Co
Page 15 and 16: CombiScan 100 Service Manual 5. Pre
Page 17 and 18: 7. Assembling instructions CombiSca
Page 19 and 20: Operation Figure 7.1.9. Turn the up
Page 21 and 22: Operation Figure 7.2.5. Replace the
Page 23: Operation Figure 7.3.7. Insert the

Service Manual Analyzer for Combi Screen® 11 SYS urine ... - Alere

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?