Johns Hobbies Catalog - JohnsHobbies.com

Johns Hobbies Catalog
DIGITRAX DETECTION SYSTEMS/SIGNA -/- DIGITRAX TRANSPONDING
BDL168 OCCUPANCY DETECTOR
DIGITRAX
12/2006
BDL162 Occupancy Detector Cost Effective LocoNet Advanced Occupancy Detection BDL16 LocoNet Universal Occupancy Detector for 16
detection sections. Complete LocoNet Occupancy detection (with NO DS54 required). Gives you local occupancy & zone power status
reporting via fascia mounted LEDs &/or computer. Use BDL162 to enable operations mode read back for decoders equipped with this
feature. $100.00 for 16 detection sections is less than $8 per detection section!
149.00US DOLLARS117.71US DOLLARS
RX4 4-ZONE TRANSPONDING
DIGITRAX
RX4 4-ZoneTransponding Receiver Add-on for BDL Series Detectors 4 ZoneTransponding Receiver Add-on for BDL16 series occupancy
detectors. Use up to two RX4s with a BDL168 to add transponding to any 8 detection sections on your layout. Use one RX4 with a BDL162 or
BDL16 to add transponding to any 4 detection sections on your layout. (Note: BDL16 & BDL162 are discontinued). -
49.99US DOLLARS39.49US DOLLARS
TF-4 QUAD FUNCTION DECODER
DIGITRAX
MSRP $20.95 TF4 Quad DCC Function Decoder TF4 Quad DCC Function Decoder with Integrated Transponder Four 125mA (250mA peak)
function output for lights or other functions Functions can be turned on/off using F0-F12 Supports both 2 digit and 4 digit addressing
Programmable from DCC compatible equipment Configurable Strobe feature lets you simulate flashing lights like FRED, Strobes, Mars Lights,
etc. on the yellow and white leads Standard On/Off Function operation available on green & violet leads. Compatible with Digitrax DCC
Transponding Systems Approximate size: 0.461? x 0.31? x 0.161? (11.7mm x 7.8mm x 4.1mm)
20.95US DOLLARS15.95US DOLLARS
TL-1 FUNCTION DECODER
DIGITRAX
MSRP $16.95 TL1 Single DCC Function Decoder TL1 Single DCC Function Decoder with Integrated Transponder Your TL1 can be used as: 1.
Function only DCC decoder with transponding 2. Digitrax Transponder 3. Function only DCC decoder without transponding. Single 125mA
(250mA peak) function output for lights or other functions Function can be turned on/off using F0, F1, F2, F3, or F4 Supports both 2 digit and 4
digit addressing Programmable from DCC compatible equipment Configurable Strobe feature lets you simulate flashing lights like FRED,
Strobes, Mars Lights, etc. Compatible with Digitrax DCC Transponding Systems Approximate size: 0.461? x 0.31? x 0.161? (11.7mm x 7.8mm
x 4.1mm)
16.95US DOLLARS13.39US DOLLARS
Page 42/265