How to make a GUI for USBCNC with Qt4 - Femtotech
How to make a GUI for USBCNC with Qt4 - Femtotech
How to make a GUI for USBCNC with Qt4 - Femtotech
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1 Preface<br />
This tu<strong>to</strong>rial will guide you through all the steps needed <strong>to</strong> setup the developing environment, configure the project<br />
and write a small <strong>GUI</strong> <strong>for</strong> the <strong>USBCNC</strong> software. Using <strong>GUI</strong>s is a powerful way <strong>to</strong> extend the functionality of your CNC<br />
machine. You should cus<strong>to</strong>mise your preferred tasks or create a user interface that meets some unusual<br />
requirements.<br />
As we will see later, interfacing <strong>with</strong> <strong>USBCNC</strong> is very easy and requires only some basic knowledge of C++<br />
programming and of the <strong>Qt4</strong> environment. Anyway, at the end of the document there are a couple of links <strong>to</strong> generic<br />
tu<strong>to</strong>rials about <strong>Qt4</strong>.<br />
Fem<strong>to</strong>tech di Marco Trapanese Via Ripamonti, 14 – 22044 Inverigo (CO) tel. 031 5481112 / 347 9431074 fax 031 2280476<br />
info@fem<strong>to</strong>tech.it www.fem<strong>to</strong>tech.it C.F. TRP MRC 81S13 B639G P.IVA 03041740139<br />
2