DBX ZonePro 1260m,1261m Install Guide (pdf)

More documents

Recommendations

Info

Section 3 Wiring 10 Diagram A Diagram B 80-1342-A RJ45 CONNECT ONLY TO ZONE CONTROLLER INPUT . Diagram C ID# 1 ID# 4 UL-6500 IEC60065 80-1342-A RJ45 CONNECT ONLY TO ZONE CONTROLLER INPUT . UL-6500 IEC60065 <strong>ZonePro</strong> TM RS-232 RS-232 ®
® <strong>ZonePro</strong> TM Diagram A Diagram B Diagram C Cable Specification: EIA/TIA 568A Standard (pin to pin) 24 AWG wire RJ-45 (8-Position) 1 2 3 4 5 6 7 8 White/Green Green White/Orange Blue White/Blue Orange White/Brown Brown RS-232 RJ-45 (8-Position) 1 -VREF 2 -Dip 1 3 -Dip 2 4 -Dip 3 5 -Dip 4 6 -Dip 5 7 -Dip 6 8 -GND Wiring RS-232 RS-232 Section 3 11
Page 1 and 2: Installation Guide
Page 3 and 4: eLectroMaGnetIc coMPatIBILIty this
Page 5 and 6: Section 1 - Introduction The ZonePR
Page 7 and 8: 1.3 Warranty This warranty is valid
Page 9 and 10: Data Wheel The Data wheel is used t
Page 11 and 12: 2.3 640/641, 640m/641m Rear Panel 6
Page 13: Section 3 - Wiring 3.1 ZonePro Wiri
Page 17 and 18: 4.1 ZonePro 640m/641m Block Diagram
Page 19 and 20: Section 4 - Technical Specification
Page 21 and 22: 640m/641m ® ZonePro TM Analog Inpu
Page 23 and 24: ® ZonePro TM 19

DBX ZonePro 1260m,1261m Install Guide (pdf)

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?