Mac OS X Installation Instructions - Belkin

® Self Installation Help Guide Instructions
Nostromo Array Programming Software (cont.)
4. After clicking on the ‘Install Nostromo N50’ the OS X install window opens.
Note:
You may have to unlock your system by supplying the installer with your
Administration Password. If so, click on the lock down at the bottom and put in your
Password in the next screen.
5. Click ‘Continue’ at the bottom right of the installer screen to continue through the
install.
6. Your ‘License Agreement’ will appear. Click ‘Agree’ to continue with the install.
7. You will now be asked to select a Destination for your Program File. Click on your
main hard drive and then click on ‘Continue’.
8. On the next screen, click ‘Install’.
9. MAKE SURE ALL OPEN WINDOWS ARE CLOSED, then click ‘Continue Install’.
10. When prompted, restart your Computer by clicking ‘Restart’.
11. Your N50 software is now installed. You may connect your Controller to your
Computer if you have not done so already.
If the Nostromo N50/N52 SpeedPad is not detected an Error Mark will appear at the top
right section of the screen saying ‘No Device Found’. If that happens, check your
connection for the N50/N52 to your Computer. If the problem persists, call Belkin
Technical Support.
In order to configure the Software, you will need to go to the ‘Applications’ Folder on
your Hard Drive and double-click on ‘Nostromo Control’. For Instructions and a
Tutorial on how to create a Profile, please review the help files on the Nostromo
Control Program menu bar.
TSG-UK-1-001 TSG-UK-6-002 | www.belkin.com | Page 1 2 of 12