Primary Rectifier Module (PFC) Data Sheet - CERN - PH-ESE group

Primary Rectifier Module PR-PFC
with sinusoidal mains input 3500W nom
• Pluggable mains input module with
sinusoidal current flow
• Power factor 0,99 for minimizing total
Harmonic Distortion (THD)
• 385VDC nominal output voltage
• 19’’ Assembly 4U for hosting up to 6
units for 22kW DC output
• Single Phase or 3-Phase operation
• Circuit breaker with thermal
protection per module, primary
• 4U x450mm 14PU width plug in unit
with input and output RF filter
• DC output fused against short circuit
Power Factor Correction Module
without housing
This self ventilated Primary Rectifier
Modules have been designed to power
MARATON systems over long distance
primarily.
Each PR-PFC is easily to withdrawal in case
of any malfunction. After switch off the
circuit breaker the module is immediately
ready for plug out.
For special request up to six PR-PFC can be
operated with paralleled outputs, presumed all
are connected to the same phase. The parallel
operated versions are not equipped with
integrated circuit breaker and need external
mains switch and fuses.
MNPFC 02.013
1

• Technical Data: Primary Rectifier
Mains Input
AC- Input: 100- 240VAC / 16A +/-10% (20A peak), 47-63Hz
CE EN 61000, IEC 555 power fact. >0,98
Inrush current: limited by soft start-circuit to 110% of nominal current (cold unit)
Input protection Circuit breaker with 16/20A thermal overload protection
Power Output 385 V DC +/- 15V, matched for MARATON DC/DC converter
continuously 9A, 3500W nom (4,4kW peak) @ 230VAC input
Regulation Load (10-90%) 1% deviation
Mains (10-90%) 1% deviation
Output ripple Load (10-90%) 1-10Vss 94-126Hz (double mains frequency)
RF rejection:
Output protection
EN 55 022 Class B, Input and Output
short circuit: 2 x 10A slow blow fuse, 500V type, internal situated
overload: current limiting for booster circuits, 90°C cut off temperature
PR- Box format: 4U x 14 TE, 450 mm deep
Front panel 14 PU width acc. to VME Spec.
Module connectors: 2mm pin / socket diameter.
max. ratings: 25A up to 50°C, 500V. 2,2kV test voltage 50Hz
PE / Ground pins outfitted as leading pin
EMC Compatibility /RFI Rejection Separate Input and Output EMC Filter
EMA EN 61 000-6-3:2001 [RF emission]
EN 55 022:1998 + Corr:2001 + A1:2000 Class B conducted noise
EN 55 022:1998+ Corr:2001 + A1:2000 Class B radiated noise
EN 61 000-3-2:2001 harmonics
EN 61 000-3-3:1995 +Corr:1997 +A1:2001 flicker
EMB EN 61 000-6-2:2001 [immunity]
EN 61 000-4-6:1996 + A1:2001 injected HF currents
EN 61 000-4-3:1996 + A1:1998 + A2:2001 radiated HF fields incl. ”900MHz”
EN 61 000-4-4:1995 + A1:2001 Burst
EN 61 000-4-5:1995 + A1:2001 Surge
EN 61 000-4-11:1994 + A1:2000 voltage variations
EN 61 000-4-2:1995 + A1:1998 + A2:2001 ESD
Operation temperature: 0....50°C without derating, storage: -30°C till 85°C
Efficiency: better than 95 %
M T B F electronics: 40°C ambient ca. 100 000 h
integrated fan: 40°C ambient ca. 65 000 h, 25° ambient >85 000h
Ordering Information
385VDC 4.4KW
1/3 phase
90-265VAC /
156-458VAC >20kW
Primary Rectifier Module PFC (1 slot),
230V 50Hz input, 385VDC output 3.5KW load 0PFC.0000
Primary Rectifier Power Bin for PFC, 6
slot 4U 0B07.0000
2

4U Primary Rectifier Power Bin for six PFCs
wiring principle
In 3- phase application the two PFC outputs which are primary powered from to the same phase can be
operated in parallel mode
MNPFC 02.013
3