ST Model MX2 EP ARTF - Addlestone Model Centre

ST Model MX2 EP ARTF A-STM050
NOW UPDATED!!!!
1) New 36A ESC for improved durability in all conditions,
2) Tinted real canopy for better scale appearance
3) Strengthened internal undercarriage mounting for better rough field durability
4) Side thrust to offset torque in hovering and low speed manouevres
Want a sports aerobatic model that is economic to buy, economic to operate and
stunning to fly? You've just found it!
The ST Models MX-2 is based on the full size, aerobatic aircraft of the same name and
then modified for model flying characteristics.
Supplied complete with powerful 920Kv brushless motor, 12 x 6 propeller, a 36A
brushless ESC, four powerful new 9g servos and with them all pre-installed. All that is
needed is 30 minutes of final assembly and applying the stunning colour decals.
Setups are provided for both sports and 3D flying (even mixes). For serious 3D pilots,
the movements make maneouvres like static loops, rolls and the 'waterfall' and
'parachute' quite within your reach.
To provide that 3D control power with precision has been achieved with a totally new
servo amplifier to give high resolution and holding power combined with strong torque.
The control pushrods are kept short by placing each servo close to the surface it is
operating.
Using a 3S 2100-2500mAh Li-Po, there is enough power to hover vertically with ease
and then punch out straight up! The choice of a 12 x 6 propeller limits the 'torque' turn
effect and eases current consumption by matching the load and motor power/Kv rating
effectively. Torque rolls are possible in both directions. Access to the battery is via a
clip-in underside hatch, simple!
Like all ST models, the airframe is moulded accurately in 'ding' resistant EPO foam. The

wings are removable by removing the two quick turn locking screws and sliding out of
the fuselage, great for compact transportation. Access to the radio compartment
requires pulling off the clip-on canopy moulding.
The tough, aluminium undercarrige soaks up those landings on our club patches so well,
but the model is hardly moving forward anyway!
As a model to hone your aerobatic skills or just cruise around on a Sunday afternoon,
the ST Models MX-2 is hard to beat.
And it looks 'cool' too!
Watch this video from one of our German Customers.
Wingspan:
Weight:
Propeller
Range:
1210mm
(47.6in)
960g
(33.8oz)
Typical
12 x 6
(Included)
Wing Area: 27.3dm2
(423.2 sq.in)
LiPo:
Intellect 3S
2100/2500mAh
20C Required
Specification
Length:
Servos:
Speed
Controller:
Wing
Loading:
Click here for video clip
1106mm
(43.5in)
4 x 9g
(Included)
36A
(Included)
35.16 g/dm2
(11.5
oz.sq.in)