U-Boot for i.MX35 based Designs - Eetasia.com

Configuration of Eclipse IDE for U-Boot Development
3. In the C/Make Project window, type a project name in the box and un-check the Use default
location checkbox as shown in Figure 2.
Figure 2. Project Name and Location
4. Click on Browse to search for the path where the U-Boot source code is located. Then, click on
Finish to close the wizard.
5. In the Eclipse main window, deselect Project > Build automatically.
6. To configure the project properties, click Project > Properties to open the Properties window:
a) Select C/C++ Include Paths and Symbols, and do the following steps:
– Disable all the automatically discovered paths and symbols (multiple selection is allowed to
disable all at once).
– Click Add include path from workspace. Then, click on U-Boot_Customized/include as
shown in Figure 3.
Figure 3. Include Path from Workspace
U-Boot ® for i.MX35 Based Designs, Rev. 0
20 Freescale Semiconductor