BUILDING CARE

BUILDING CARE
MedTech /Vinyl floor
Initial Floor Preparation (Following Installation)
1. Remove all surface soil/debris by sweeping or dust
mopping.
2. Scrub floor with TASKI Profi (4 oz/gal). Use
autoscrubber for large areas or buffer for small areas.
Use Taski mint pads.
3. Pick up soiled solution with wet vac or autoscrubber.
Allow floor to dry.
4. Apply 2 coats of floor finish.
5. Option 1:For high shine use TASKI Vision Star.
6. Option 2:For matte shine use TASKI Vision Matte .
7. Option 3:Spray buff floor use Taski Ultra Spray.
Regular Maintenance:
1. Dust mop floor.(Use TASKI Solsan dust mop treatment)
2. Wet mop floor or autoscrub (use detergent appropriate for
facility TASKI NDC disinfectant, R50, Wiwax, or
Combiplus).
Option 1: Dry buff. Use pink pad. (as needed)
Option 2: Spray clean and protect. Use TASKI ultra
spray with pink pads.
Restorative Maintenance:
• Dust mop floor
Option 1: Top scrub and recoat (use TASKI R50 2-3 oz/gal
and purple pads).
Option 2: (As needed) Wet strip (use TASKI radical 15-25
oz/gal).
Option 3: Dry strip with TASKI Stripo.
• Apply 1-2 coats of floor finish.

Tip and Suggestions
• Do not strip floor with high pro pads.
• Do not burnish floor with burnishers over 1500 rpm.
• For TASKI Vision Matte : dry buff and top scrub and
recoat to maintain low shine.
• Do not use floor sealer on floor.