AP2003 / AX2002

EXTENDED AEBUS CONNECTIONS (AX2002)
The connector for the extended AEbus is
located above the AEbus connector. Only the
communication is extended, not the power
supply (this is achieved from the Power AEpack
on which the AX2002 is installed).
Using 2 x 2 x 0,50 mm² shielded cable means
that CH and CL must be one twisted pair.
From the other pair only one cable is connected
to GND. The cable shield must be connected to
the housing of the AEbox.
AP2003 / AX2002
SPECIFICATIONS AP2003 (Product nr. 9839720)
Dimensions: 230 x 126 x 70 mm (excluding mounting rail) Weight: ± 600 gr
Output: AEbus power: 27 VDC, max 1,3 A
Environment: Temperature: Operating: 0 – 55 °C, Storage: -30 – 65 °C Relative humidity: 10 – 93% non condensing
Power: 230 – 240 VAC (-10%+6%) 50/60 Hz, (max 0,42 Amp at 230 VAC)
Safety: Class I
CABLE SPECIFICATIONS
230 VAC Power: 3 x 0,75mm², due to local restrictions, must have earth connection
FUSES
230 VAC F1 3,15A SB
Resistor ON for
first and last
AX2002
AX2002 first AX2002 n+1 AX2002 last
CH
CL
GND
Resistor OFF for
all AX2002’s
between
AEbus extender connectors
rear view
It is not allowed to make a STAR connection. The extended AEbus (and also the AEbus) may only be
connected in LINE.
FIRMWARE
Pay attention that the firmware loaded in AEpack and AEpu determines functionality and protocols.
SPECIFICATIONS AX2002 (Product nr. 7818386)
Dimensions: Fits into Power AEpack (e.g. AP2001 / AP2003)
Extended AEbus: AEbus communication, no power
Environment: Temperature: Operating: 0 – 55 °C, Storage: -30 – 65 °C Relative humidity: 10 – 93% non condensing
CABLE SPECIFICATIONS
Extended AEbus: 2 x 2 x 0,50mm² shielded, total length extended AEbus: max 300 meter (CH and CL must be twisted)
MORE INFORMATION: For more detailed information contact your local Nedap supplier or check the internet site.
Resistor ON for
first and last
AX2002
© Nedap N.V. AP2003 / AX2002 Installation sheet Page 4 of 4