2010 ECO-i Tech Tips - Panasonic

More documents

Recommendations

Info

• Heat Sink Paste When replacing a circuit board Apply a thin layer of Heat Sink Paste (Supplied) on the HIC and Main PCB boards on the outdoor units
Installing Distribution Joint The direction of the distribution joint kit should be horizontal or vertical. The direction of each I/U must be upward (15~30). ● It is suggested that soft-drawn, ACR grade tubing be used in all cases to minimize equivalent length of tubing run, and leak potential. ● Hard-drawn tubing may be used, if necessary, with long radius elbows. ● 15% silver brazing material is recommended on all solder joints. ● Factory supplied distribution joints (purchased separately) must be used where specified. ● Field installed ball valves, with access ports, are recommended on both branch lines to an indoor unit.
Page 1 and 2: ECOi Technical Tips
Page 3 and 4: U Series Increasing fan Speed If Ex
Page 6 and 7: A good communication line should re
Page 8 and 9: Possible Causes: The Dip switches
Page 10 and 11: • Change in Shield grounding proc
Page 14 and 15: L2 LM LA H1 H2 LB m1 LC m2 m3 m4 It
Page 16 and 17: Evacuation and Charging Procedures
Page 19 and 20: Summary of Rotary Dials and Dip Swi
Page 21: Main things to remember Complete pi

2010 ECO-i Tech Tips - Panasonic

Create successful ePaper yourself

Delete template?

Save as template?