15.08.2013 Views

Sym DD Servicemanual - Scootergrisen

Sym DD Servicemanual - Scootergrisen

Sym DD Servicemanual - Scootergrisen

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Transmission Oil<br />

Leak<br />

Check if the transmission is leak.<br />

Check<br />

Caution<br />

Park the scooter on flat ground with its main<br />

stand.<br />

Remove the oil level check bolt, and check if the<br />

oil level is placed on the hole of check bolt.<br />

Replacement<br />

Remove the oil level check bolt.<br />

Remove the oil draining bolt, and then drain oil<br />

out.<br />

Install the oil draining bolt.<br />

Tighten torque: 1.3 kgf-m<br />

Caution<br />

Check if oil seal and washer is in good<br />

condition.<br />

Replacement Quantity: 0.09 L (90 cc)<br />

Recommended oil: King Bramax HYPOID<br />

GEAR OIL #140<br />

Spark Plug<br />

Recommended plug: NGK BR8HSA<br />

Remove the luggage box.<br />

Remove the spark plug cap.<br />

Clean any dirt on the spark plug seat.<br />

Remove the spark plug.<br />

Visually inspect the spark plug electrodes for<br />

wear.<br />

The center electrode should have square<br />

edges and side electrode should have a<br />

constant thickness. Replace the spark plug if<br />

there is apparent wear or if the insulator is<br />

cracked and/or chipped. If the spark plug<br />

deposits can be removed by sandpaper, the<br />

spark plug can be reused.<br />

Measure the spark plug gap with feeler<br />

gauge.<br />

Spark plug gap: 0.6-0.7mm (0.024-0.028in)<br />

Adjust the gap by careful bending the side<br />

electrode.<br />

Install the spark plug by screwing it with<br />

hands after installed the spark plug washer<br />

so that can prevent the plug from out of<br />

thread. Then, tighten the spark plug with a<br />

spark plug wrench.<br />

Install the spark plug cap.<br />

This chapter Contents<br />

2. SERVICE MAINTENANCE INFORMATION<br />

Draining bolt<br />

0.6~0.7mm<br />

Side electrode<br />

Center electrode<br />

Oil level check bolt<br />

Oil level check bolt hole<br />

2-11

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!