Thermal Dynamics 15C Drag-Gun LT Operating Manual_(4965)
Thermal Dynamics 15C Drag-Gun LT Operating Manual_(4965)
Thermal Dynamics 15C Drag-Gun LT Operating Manual_(4965)
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Drag</strong>-gun lt<br />
Appendix 1: <strong>Operating</strong> Sequence, Block Diagram<br />
Primary Input Power "On" or Plugged in<br />
Green Power Indicator "On" and Fan is Running<br />
YES<br />
Power Supply On/Off Switch "On"<br />
Torch Switch "On"<br />
Compressor and Pilot Arc Ignition starts<br />
Start Cutting Operation<br />
Cutting Done ?<br />
Release Torch Switch<br />
Post Flow of Air, Approximately 12 Seconds Then Stops<br />
Note: The Torch will be very hot!<br />
Do not set on or near flammable materials!<br />
Power Supply On/Off Switch "Off"<br />
Green Power Indicator "Off" and Fan Stops<br />
Primary Input Power Switch "Off" or Unplugged<br />
No Pilot Arc<br />
Check Torch parts alignment.<br />
(PIP switches need to be repaired<br />
by a Qualified Technician.<br />
More air flow is required for<br />
Torch to Pilot than to run the<br />
power supply.<br />
Compressor not functioning<br />
properly needs to be repaired<br />
by a Qualified Technician)<br />
Art # A-07874<br />
<strong>Manual</strong> 0-<strong>4965</strong> A-1 APPENDIX