why geyser blankets - Eskom

More documents

Recommendations

Info

DSM AUDIT PROCEDURE (cont) If geyser is not properly covered at inlet and outlet ends - Reject If pipes are not insulated for at least 3 meters or up to a wall entrance - Reject If dampness due to geyser leakage is found - Reject If materials used differ (provide less insulation) from contracted material - Reject
CPUT GEYSER BLANKET AUDIT PROCEDURE FOR GEYSERS & PIPES Measure water temp from tap nearest geyser, after running water for 1 min Is blanket material SABS approved ? Inspect blanket installation for : Coverage (
Page 1 and 2: M&V Guideline for Geyser Insulation
Page 4 and 5: WHY GEYSER BLANKETS ? ESKOM has to
Page 7 and 8: COMMENTS Smaller impact on standin
Page 11: DSM AUDIT PROCEDURE If insulation
Page 15 and 16: NWU ‘APPLICATION APPLICATION’ T
Page 17 and 18: Metering: Electricity Electricity c
Page 19 and 20: METHODOLOGY : GEYSER & PIPE INSULAT
Page 21: FORMS Metering procedure With blank
Page 25 and 26: Geyser Insulation M&V Tool Inputs i
Page 27 and 28: Geyser Insulation M&V Tool Output:
Page 29 and 30: Fieldworker form : GEYSER INSULATIO
Page 31: TABLE :

why geyser blankets - Eskom

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?