Installation Manual - Fatra

More documents

Recommendations

Info

Moisture indicator CM machine Base hardness tester Measuring wedge Porcupine aeration roller Toothed scraper Straight knife Hooked knife Steel strip Tile cutter Knife for accurate orthogonal cutting of floor covering edges next to walls Circular cutter
Circular knife Chamfer plane Drawing instrument Sectional roller Vertical scriber Groove knife Groove cutter Hot-air welding machine Trimming knife with guide piece Cold-welding kit Polish applicator Floor covering remover
Page 4 and 5: 1. INTRODUCTION....................
Page 6 and 7: 1. INTRODUCTION This manual is a re
Page 8 and 9: ecommend grinding off the top layer
Page 12 and 13: 5.2. Applying the adhesive We stron
Page 14 and 15: The weld area must be slightly shin
Page 16 and 17: 8.8 Bonding large tile areas In ord
Page 18 and 19: Arrange the conductive mesh onto th
Page 20 and 21: 9.1.6. Fatra - Bralep system This f
Page 22 and 23: 9.2.3. Fatra - Uzin system This flo
Page 24 and 25: • Bralep 280 L conductive coat
Page 26 and 27: Start the installation in a corner
Page 28 and 29: • A white rubber hammer must be u
Page 30 and 31: 14.1.4. Comprehensive cleaning Comp
Page 32 and 33: 14.3. Recommended products for clea
Page 34 and 35: 15.1 Organic substances TYPE OF CHE
Page 36: However, abrasion does not mean wea

Installation Manual - Fatra

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?