Modeling Component Assembly of a Bearing Using Abaqus - SIMULIA

More documents

Recommendations

Info

22 Comments and Closure • Modeling of a bearing assembly procedure was considered in this paper using the special techniques in Abaqus, i.e. Model change. Contact interference fit. • The example demonstrates the high-quality capability of Abaqus to simulate real world designs. • Multiple cases in which design parameters, i.e. initial overclosure values were varied allowed their sensitivity to be understood. • The results were then used in the structural integrity and component fatigue life evaluations of the existing equipment to aid in an improved fatigue resistant design.
23 Contact Information Mike Guillot, Mike.Guillot@stress.com Bisen Lin, Bisen.Lin@stress.com Stress Engineering Services 13800 Westfair East Drive Houston, Texas 77041 Phone: (281) 955-2900 Fax: (281) 955-2638 www.stress.com
Page 1 and 2: Modeling Component Assembly of a Be
Page 3 and 4: 3 Overview • Abaqus modeling tech
Page 5 and 6: 5 Modeling Technique (2/2) • Cont
Page 7 and 8: 7 Middle Layer (Cooling Sleeve) Axi
Page 9 and 10: 9 Young's Modulus (psi) 3.00E+07 2.
Page 11 and 12: 11 Int-3 Contact Interactions Int-1
Page 13 and 14: 13 Model Assemble and Analysis Proc
Page 15 and 16: 15 Analysis Results of Case C-1 (1/
Page 17 and 18: 17 Analysis Results of Case C-1 (3/
Page 19 and 20: 19 Results of Sensitivity Study (2/
Page 21: 21 Results of Sensitivity Study (4/

Modeling Component Assembly of a Bearing Using Abaqus - SIMULIA

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?