Modeling Component Assembly of a Bearing Using Abaqus - SIMULIA

More documents

Recommendations

Info

8 Material Properties (1/3) • Bearing housing is made of AISI 4140 low alloy steel. • Other parts, i.e. cooling sleeve and bearing sleeve, and welds are made of 1026 low carbon steel. • Temperature-dependent mechanical and thermal properties including Young’s modulus, coefficient of thermal expansion, and thermal conductivity are shown in the next slide. Poisson’s ratio of 0.3 is used.
9 Young's Modulus (psi) 3.00E+07 2.90E+07 2.80E+07 2.70E+07 2.60E+07 2.50E+07 Material Properties (2/3) 0 100 200 300 400 500 600 700 Temperature (F) 1026 Steel 4140 Steel
Page 1 and 2: Modeling Component Assembly of a Be
Page 3 and 4: 3 Overview • Abaqus modeling tech
Page 5 and 6: 5 Modeling Technique (2/2) • Cont
Page 7: 7 Middle Layer (Cooling Sleeve) Axi
Page 11 and 12: 11 Int-3 Contact Interactions Int-1
Page 13 and 14: 13 Model Assemble and Analysis Proc
Page 15 and 16: 15 Analysis Results of Case C-1 (1/
Page 17 and 18: 17 Analysis Results of Case C-1 (3/
Page 19 and 20: 19 Results of Sensitivity Study (2/
Page 21 and 22: 21 Results of Sensitivity Study (4/
Page 23: 23 Contact Information Mike Guillot

Modeling Component Assembly of a Bearing Using Abaqus - SIMULIA

Create successful ePaper yourself

Delete template?

Save as template?