tiptronic 6270.pdf - Pfaff

hfld this is the way to do it:
Remove the sewing foot.
place the eyelet plate on the needle elate,
aaking sure pin A fits in the middle cutout of the
peedle plate. Then push the plate down at the
front
place the marked fabric tightly in an embroidery
hoop.
TIP: If you choose another program. i.e. 55 or 57,
the cut will only be partly stitched around, or not at
all. To complete this, just select Program 1 2 after
iards and stitch evenly around the cut. This is how
beautiful blossoms can he made, too.
• Cut one or two of the fabric threads and push the
fabric over the pin in the eyelet plate. The fabric
must fit snugly around the pin.
• Set the presser bar lifter at the darning position.
• Draw up the bobbin thread and hold it for the
first few stitches.
• You can now stitch around the cut with the
selected program. When you do this it is impor
tant to turn the fabric slowly and evenly. The
stitches should be close to each other.
• Afterwards secure with a few straight stitches.
99
a,
e0
2 a,
C,
a)
>-