CIMD Interface Specification - Elisa

CIMD Interface Specification
When connected to an SMS Center, the receiving type SMEs can also be set up
in such a way that messages stored in the SMS Center are not sent automatically
when the SME logs in. In such a case, the SME receives new incoming messages,
but it has to query for the old messages stored in the SMS Center. This is not
supported by the USSD Center due to the nature of USSD.
The type of the SME must be specified before the SME may operate. The type,
along with other information about the SME, is stored in the MC.
3.2 Operations from the SME to the MC
Operation Definition
Table 1 lists operations from the SME to the MC.
Table 1. Operations from SME to MC
Login This operation is used by all SMEs before any operations.
Logout This operation is used by all SMEs to indicate the end of the
session. The logout operation does not release the connection.
Therefore, a disconnect must be explicitly performed after the
logout.
Submit This operation is used by the SME to send messages to MSs
and/or other SMEs. In the submit operation, the SME can request
transmission of status reports for the message.
Delivery request This operation is used by the SME to retrieve messages.
Cancel This operation is used by the SME to cancel messages it has sent.
Enquire message
status
This operation is used by the SME to request a status report for a
previously submitted message.
Set This operation is used by the SME to change the values of those
interface parameters that it is allowed to change.
Get This operation is used by the SME to inquire the values of the
interface parameters.
3.3 Operations from the MC to the SME
Table 2 lists operations from the SME to the MC.
16 (74) © Nokia Corporation DN99255924
Nokia Proprietary and Confidential Issue 5a-0 en