TECHNICAL RULES MOTOCROSS (INCLUDING RULES FOR ... - FIM
TECHNICAL RULES MOTOCROSS (INCLUDING RULES FOR ... - FIM
TECHNICAL RULES MOTOCROSS (INCLUDING RULES FOR ... - FIM
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The front edge shall be raised in a curve with a diameter of not less than 100 mm<br />
which shall continue as far as a vertical line running through the centre point of the<br />
circle created by the curve. Material to be used: minimum 12 mm outside diameter.<br />
Any guide rail must be made of material with a circular section and a minimum<br />
diameter of 10 mm. If it is equipped with anti-skid rail, the minimum profile angle is<br />
60° and the maximum length 260 mm (see diagram M).<br />
The edges of steering skis must be rounded with a profile of steel or another metal of<br />
at least 5 mm (see diagram M).<br />
82.17 Number plates<br />
Number plates are compulsory. Article 01.55 is applicable.<br />
82.18 Number plate colours<br />
82.19 Fuel and Oil<br />
Up to 250 cc green background white numbers<br />
350 cc blue background white numbers<br />
500 cc yellow background black numbers<br />
1050 cc white background black numbers<br />
1300 cc red background white numbers<br />
Article 01.63 is applicable. Anti-freeze liquid is permitted.<br />
82.20 Equipment and protective clothing<br />
Article 01.65 is applicable.<br />
82.21 Bibs<br />
Article 01.76 is applicable.<br />
82.22 Control/Verification<br />
Article 01.77 is applicable.<br />
82.23 Sound control<br />
Article 01.79 is applicable.<br />
The maximum sound: see Art.01.79.<br />
During a snowmobile sound test, the machine must be placed on a bridge 1m off the<br />
ground, with a microphone placed at an angle of 90° at a distance of 100 cm from the<br />
exhaust pipe. All power train must be released from the engine. Hood and cowling<br />
must be installed.<br />
53