TransNav TL1 Command Reference Guide, TN5.0 - Force10 Networks

Example:
TL1>>RTRV-NE:Force10::1;
FORCE10 09-03-27 12:07:32
M 1 COMPLD
"NODEID=Force10,TYPE=16-SLOT
NODE,NDIPADDR=10.42.27.3,BKIPADDR=10.42.27.3,BKGWIP=10.42.1.1,BKIPMASK=255.255.0.0,EMSIP
ADDR=,EMSIPMASK=,EMSGWIP=,GCMAIPADDR=,GCMAIPMASK=,GCMAGWIP=,GCMAMAC=00:01:B5:06:DF:50
,GCMBIPADDR=,GCMBIPMASK=,GCMBGWIP=,
GCMBMAC=,NTP1IPADDR=10.42.254.41,NTP2IPADDR=,LOCATION=,TZ=America/Los_Angeles,STANDARD=ANSI_
DEFAULT,OPMODE=ADM,MSAIDFMT=
NO-MSAID,PROXYARP=DISABLED,OSPFOVERDCN=DISABLED,ALMPROF=default,EXTALM1=NONE,EXTALM2=
NONE,EXTALM3=NONE,EXTALM4=NONE,EXTA
LM5=NONE,EXTALM6=NONE,EXTALM7=NONE,EXTALM8=NONE,EXTALM9=NONE,EXTALM10=NONE,EXTAL
M11=NONE,EXTALM12=NONE,EXTALM13=NONE,EXT
ALM14=NONE,EXTALM15=NONE,EXTALM16=NONE"
;
TARGET: TRAVERSE, TE100
SET-SYS
General Description
This command is used to reset the system parameters, which will take effect only after
system reset. This command will cause system to reset.
Command Syntax
SET-SYS:[]:::::[NODEID=],[NDIPADDR=],
[STANDARD=],[OPMODE=],[BW=];
8 TransNav Management System TLI Guide, Release TN5.0.x