Agusta A119 Koala - Graupner
Agusta A119 Koala - Graupner
Agusta A119 Koala - Graupner
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Agusta</strong> <strong>A119</strong> <strong>Koala</strong><br />
Completing the chassis<br />
Attach the helicopter chassis (complete with tail boom and boom braces) to the base plate using<br />
the four screws with which the original skid landing gear was secured. Attach the speed<br />
controller to the underside of the base plate so that the ON / OFF switch is easily accessible<br />
when the model is complete.<br />
The upper bodywork stand-off pillars<br />
consist of a 70 mm length of 2 mm Ø<br />
carbon fibre rod. Drill a 2 mm Ø hole<br />
in both chassis side frames as shown<br />
in the photo, and push the rod<br />
through them. Adjust the position of<br />
the rod so that it projects by exactly<br />
the same amount on both sides. Cut<br />
two pieces 21 mm long from the 3 / 2<br />
mm Ø plastic tube, push them onto<br />
the carbon fibre rod as far as they will<br />
go, and secure them with cyano.<br />
10
Change language