Agusta A119 Koala - Graupner
Agusta A119 Koala - Graupner
Agusta A119 Koala - Graupner
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Agusta</strong> <strong>A119</strong> <strong>Koala</strong><br />
Drill two 2 mm Ø holes in each of the carbon fibre skid tubes, taking care to drill at exactly the<br />
same angle: the rear ones should be 22 mm from the end, and the front ones spaced 135 mm<br />
from them. Caution: do not drill right through the tubes: just drill into them!<br />
Fit the two skid bars into the holes "dry" (no<br />
glue), and tape the skid tubes down on a flat<br />
surface as shown: the tubes should be 108<br />
mm apart, perfectly "square" and parallel to<br />
each other.<br />
Remove the skid bars from the skid tubes<br />
without disturbing the tubes, and slide lengths<br />
of 3 / 2 mm Ø plastic tube onto them; the ends<br />
of the steel bars should project by about 4<br />
mm; roughen the exposed ends using<br />
abrasive paper.<br />
Now fit the skid bars into the (still fixed) skid<br />
tubes, set them parallel to each other and tilted<br />
to the rear slightly, then glue them securely to<br />
the skid tubes using cyano.<br />
Glue a 20 mm long beech dowel in the front<br />
end of each carbon fibre tube, leaving half their<br />
length projecting.<br />
8