PDF 13,6 MB - Turolla

More documents

Recommendations

Info

OpenCircuitGear MEMBER OF THE SAUER-DANFOSS GROUP SGM2 and SGM3 Fan Drive Gear Motors Technical Information SGM2VC – Group 2 Fan Drive Gear Motors Mounting flange and shaft options Turolla OCG offers two types of industry standard mounting flanges. The table below shows order codes for each available mounting flange and its intended use: A B C D E F G H I J K L M N S G M 2 V C / A N N N N N N N N / Flange/Shaft Maximum torque Code Description Code 02 flange Code 06 flange 02AA 06BA 06GB European, pilot Ø 80 mm [Dia 3.15 in], 4-bolts Taper 1:5, Key 3 – M12 x 1.25 SAE A, pilot Ø 82.55 mm [Dia 3.25 in], 2-bolts Taper 1:8, Key 4 – M12 x 1.25 SAE A, pilot Ø 82.55 mm [Dia 3.25 in], 2-bolts Parallel Ø 15.875 [Dia 0.625], L 50.8 [2] 140 N•m [1239 lb•in] – – – 150 N•m [1328 lb•in] 80 N•m [708 lb•in] Spline configuration is not available for Group 2 fan drive motors. Other shaft options may exist. Contact your Turolla OCG representative for availability. CCaution Shaft torque capability may limit allowable pressure. Torque ratings assume no external radial loading. Applied torque must not exceed these limits, regardless of stated pressure parameters. Maximum torque ratings are based on shaft torsional fatigue strength. 42 L1016036 • June 2010 • Rev A
OpenCircuitGear MEMBER OF THE SAUER-DANFOSS GROUP SGM2 and SGM3 Fan Drive Gear Motors Technical Information Notes L1016036 • June 2010 • Rev A 43
Page 1 and 2: SGM2 and SGM3 Fan Drive Gear Motors
Page 3 and 4: OpenCircuitGear MEMBER OF THE SAUE
Page 41: OpenCircuitGear MEMBER OF THE SAUE

PDF 13,6 MB - Turolla

Create successful ePaper yourself

Delete template?

Save as template?