ProAc STUDIO CENTRE CHANNEL - Hifi Gear
ProAc STUDIO CENTRE CHANNEL - Hifi Gear
ProAc STUDIO CENTRE CHANNEL - Hifi Gear
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>ProAc</strong> <strong>STUDIO</strong> <strong>CENTRE</strong> <strong>CHANNEL</strong><br />
A stunning new Centre<br />
Channel from <strong>ProAc</strong>.
<strong>ProAc</strong> <strong>STUDIO</strong> <strong>CENTRE</strong> <strong>CHANNEL</strong><br />
For over a decade, the <strong>ProAc</strong> Response CC1 has been a firm<br />
favourite for use in all makes of home cinema systems.<br />
During the design of the CC1, great care was taken in<br />
matching crossover frequencies and balance, not only for<br />
<strong>ProAc</strong> loudspeakers, but also for compatibility with other<br />
manufacturers’ products.<br />
With the advent of higher dynamics, bandwidth and speech<br />
emanating from the centre, we decided to design a new<br />
centre channel which would effectively reproduce this extra<br />
information. The new Studio Centre Channel has taken two<br />
years to perfect. The cabinet is marginally bigger than the<br />
CC1 with two new bass drivers and is front ported as<br />
opposed to the rear ported design of the CC1. This allows for<br />
improved matching and placement, making the Studio Centre<br />
Channel a perfect match for the entire <strong>ProAc</strong> range. Careful<br />
crossover design has also meant that it is highly suitable for<br />
use with other makes of home cinema speakers, bringing an<br />
open and natural quality to centre channel reproduction.<br />
The Studio Centre makes an obvious partner for the Studio<br />
110/130/140 models. A 5 inch version of the 6 1 ⁄2 inch bass<br />
driver used in the Studio range was designed using a special<br />
coated pulp cone and partnered with a new version of the<br />
Studio range tweeter, incorporating a shielded magnet<br />
system which will prevent interference with CRT monitors.<br />
Great emphasis was placed in the design process to produce a<br />
natural, open midrange with extra bandwidth for the music and<br />
sound effects reproduced by the centre channel. Efficiency and<br />
sensitivity have been improved over its predecessor and there<br />
is also greater bass extension and power.<br />
In summary, the <strong>ProAc</strong> Studio Centre Channel is a perfect<br />
match for our Studio and Response ranges or any good<br />
quality system where an excellent, compact centre channel<br />
is required.<br />
Specification<br />
Nominal Impedance<br />
Recommended Amplifiers<br />
Frequency Response<br />
Sensitivity<br />
Bass/Midrange Driver (2)<br />
Tweeter<br />
Crossover<br />
Dimensions<br />
Weight<br />
Mode<br />
Finish<br />
4 ohms<br />
10 to 150 watts<br />
35hz to 30Khz<br />
89db linear for 1 watt at 1 metre<br />
Shielded 5” (130mm) <strong>ProAc</strong> unit with special coated pulp cone.<br />
Shielded 1” (25mm) soft silk dome with special inner damping.<br />
HQC network with studio range matched slopes using the finest components, wired with<br />
multistrand oxygen free cable, split for bi-wiring/amping<br />
7 3 ⁄4” (197mm) high<br />
17 1 ⁄4” (439mm) wide<br />
8” (204mm) deep<br />
20lbs (9kgs)<br />
Horizontal on television/shelf/stand<br />
Available in the following real wood veneers: Cherry, Maple, Black Ash and Mahogany.<br />
* Due to our policy of continuous improvement all specifications are subject to change without notice. Cabinet pictured is finished in Maple<br />
real wood veneer. Since wood is a natural product both colour and grain patterns may vary.<br />
Highpoint House, Riding Road, Buckingham Road Industrial Estate, Brackley, Northamptonshire NN13 7BE<br />
Telephone 01280 700147 Fax 01280 700148 Website www.proac-loudspeakers.com<br />
Printed in England