Yamato ADP21, ADP31, Vacuum Drying Oven Instruction Manual

In the Event of Failure…
Safety Device and Error Code
This unit has an automatic diagnosis function built in the controller and safety devices independent of the
controller. The table below shows the cause and the solution method when the safety device operates.
Error Code:
When an abnormal condition occurs, an error code appears and the alarm lamp lights in the controller,
the buzzer sounds simultaneously. Record the error code and turn off the power of device
immediately.
Safety Device Notify Cause/Solution
Sensor trouble detection
SSR short-circuit detection
Heater disconnecting detection
Memory error
Internal communication error
Overheating
Measurement temperature
error
“ALARM” lamp lights on,
“Er.01” appears
“ALARM” lamp lights on,
“Er.02” appears
“ALARM” lamp lights on,
“Er.03” appears
“ALARM” lamp lights on,
“Er.15” appears
“ALARM” lamp lights on,
“Er.17” appears
“ALARM” lamp lights on,
“Er.19” appears
“ALARM” lamp lights on,
“--------” appears
• Temperature sensor is broken or
disconnected.
• Make a call for service.
• Triac is in short-circuit
• Make a call for service.
• Heater is disconnected.
• Make a call for service.
• Failure in internal memory.
• Make a call for service.
• Failure in internal communication or
temperature inputting circuit.
• Make a call for service.
• Overheating prevention device is in
operation.
• Reset the power supply, and then
adjust the setting temperature of the
overheating protection device.
• If the state does not recover, make a
call for service.
• Measurement value is out of display
range.
• Make a call for service.
25