Russell Performance Catalogue - Pirate4x4.Com

POWERFLEX POWER STEERING HOSE ENDS
STAINLESS BRAIDED
HOSE FOR HIGH
PRESSURE POWER
STEERING LINES
For high pressure power steering lines,
PowerFlex Power Steering Hose is the
preferred choice. When used in conjunction
with Russell’s PowerFlex hose ends, the end
result is a durable and professional hose
that resists leaks, providing years of service.
A choice of power steering adapters is
available to allow the connection to most
pumps, feed, pressure and return lines.
• Teflon ® inner liner with 308 stainless
steel braid
• Hose is rated at 2500 psi
• Use with super strength high alloy
steel PowerFlex Hose Ends for
enhanced reliability
• Select the appropriate power steering
adapter to complete the assembly
HOSE ASSEMBLY TOOL
This handy tool separates the steel braid from
the teflon inner liner making insertion of the
olive easier.
SIZE PART #
-3 & -4 651970
-6 & -8 651971
POWERFLEX SPECIFICATIONS
SIZE ACTUAL I.D. NOMINAL I.D. O.D. MAX PSI
-6 11/32" 3/8" 7/16" 2500
-8 7/16" 1/2" .565" 2500
-10 9/16" 5/8" .656" 2500
POWERFLEX PRE-PACKAGED ROLLS
SIZE 3' 6' 10' 15' 20'
SINGLE BULK*
-6 632600 632609 632610 632620 632630 632640
-8 632660 – 632670 632680 632740 –
-10 632710 632718 632720 632730 632770 –
*Packaged in quantity of 25 pcs.
HOW TO ASSEMBLE POWERFLEX HOSE & HOSE ENDS
Step One: Wrap the hose tightly with electrical or
racers tape. Hold the hose firmly in a vise without
crushing and cut through the tape. Make sure you
make a straight cut. Remove the tape slowly and
deburr the Teflon ® edges. Install the socket on the
hose and slide it back out of the way.
Step Three: Push the olive sleeve around the Teflon ®
and between the braid. This can be done by pushing
the sleeve against the side of your workbench or
vise. Be sure the Teflon ® liner is square to the bottom
of the olive. With the nipple in the vise, lube the
threads and the nipple portion of the hose end
sparingly. Insert the hose over the nipple making
sure the olive does not pop off the Teflon ® tube.
Listings in red are new!
ADVANCED FLUID TRANSFER SYSTEMS
Step Two: Insert the nipple portion of the
PowerFlex hose end in a vise. Slip the hose over
the nipple using a twisting motion to size the I.D.
of the teflon. Separate the wire braid from the O.D.
of the Teflon ® tube with a small screwdriver.
Be careful not to crush the Teflon ® .
Step Four: Start the socket onto the nipple by
hand. Tighten with a wrench until the gap between
the nipple and the socket is no more than 1/16".
Clean the hose assembly and pressure test
before using.
15
PROCLASSIC HOSE HOSE & HOSE ENDS ADAPTER FITTINGS QWIK RELEASE FUEL MANAGEMENT ACCESSORIES BRAKE HOSES DEALER INDEX