CHAMPIONS®- Torque Wrench - Champions-Implants

2
When implanting, you should read the „IN“ from above.
Please take a look at the indications on the left side of the torque wrench- you see the following
indications:
20 – 40 – 60 – 80 – endless (from the bottom to the top)
Start to adjust the torque wrench at torques of 20, 30 or 40 Ncm (you can adjust the torque with the small wheel
at the bottom end of the wrench) and when implanting, from above, observe the movement of the line in
the middle of the indication!
Ideally, a Champion implant should be inserted at a torque of 40 Ncm! However, if the torque wrench bends at a
torque of 40 Ncm, do not yet stop inserting!
This value only means that the implant can be loaded immediately, provided that it is not an implant for a missing
single tooth in the upper jaw.
PLEASE NOTE: If a torque of more than 60 Ncm has been reached, there are two possibilities:
(Tulip heads can break at approximately 80 Ncm, Champions- implant threads or square-shaped implant heads can
break at a torque of 100-120 Ncm):
1) If a torque of more than 60 Ncm has been reached, take out the implant completely. In order to widen the
bone cavity, use the black drill and eventually also the white three-square drill or the 2mm- twist drill.