LIM-2 Logic Inspection Module

Hookup, Inspection/rejection Application (continued from page 5)
Switch settings (beneath module cover)
Model Description Notes
1 2 3 4 5 6 7 8
B4-2-1500B
One-shot
inspection/rejection
Table 2. Using the LIM-2 to Replace other Banner Modules
OFF
OFF
ON
ON
OFF
ON
OFF
ON
Product sensor (interrogate) input at pin #5;
Inspection sensor (data) input at pin #3;
Output (pulse) at pin #8
BIC-2
"Flip-flop"
(toggle)
OFF
OFF
ON
ON
OFF
ON
ON
OFF
Jumper pin #8 to pin #3;
Input at pin #5;
Output at pin #6
DP-1A
Interrogation module;
Die protection & other
inspection sequences
ON
OFF
OFF
ON
ON
OFF
ON
OFF
Cycle input (set) at pin #5;
Part detection (reset) at pin #3;
Output (latch) at pin #6
TL2A
Train logic module
for code reading or
"no can/no fill"
OFF
OFF
ON
ON
OFF
ON
ON
OFF
Strobe input at pin #5;
Data input at pin #3;
Output (latch) at pin #6
WARRANTY: Banner Engineering Corporation warrants its products to be free from defects for one year. Banner Engineering Corporation will
repair or replace, without charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty
period. This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other
warranty either expressed or implied.
Banner Enginnering Corp. 9714 10th Avenue No. Minneapolis, MN 55441 Telephone: (763) 544-3164 FAX (applications): (763) 544-3573