K&F SEQUENZA 10 N/W/B & Flying Frame - Kling und Freitag

User's manual
K&F SEQUENZA 10 N/W/B & Flying Frame
10.1.3 ArraywithSEQUENZA10N/WandSEQUENZA10B
1. Create an array with SEQUENZA 10 N/W, see chapter [Array with SEQUENZA 10 N/W] as of page 18.
2. Create an array with SEQUENZA 10 B, see chapter [Array with SEQUENZA 10 B] as of page 22.
3. Remove the 4 Quick Release Pins (A) on the
flying frame of the SEQUENZA 10 N/W array
and turn out the 4 angled joint plates (B), as
illustrated.
Secure the angled joint plate (B) with the
Quick Release Pin (A) in this position.
Proceed accordingly with the 3 remaining
angled joint plates of the flying frame.
4. Push the SEQUENZA 10 N/W array and the
SEQUENZA 10 B array together so that all 4
angled joint plates of the flying frame protrude
into the connecting brackets of the
lower SEQUENZA 10 B system.
5. Secure all 4 angled joint plates with the remaining
Quick Release Pins on the bottom
SEQUENZA 10 B system.
6. Wire the speakers. Further information in chapter "Wiring" on page 42. Please find more detailed
information for wiring the SEQUENZA 10 speaker and configuring the CD 44 in the hardware
user's manual for the CD 44. SEQUENZA 10
KLING & FREITAG GMBH © 2009 Revision 6.0 Page 25 of 65