Produktinfo E allgemein 700 & 900 - KS Paul GmbH

PRODUCT - INFORMATION
MOLY-PAUL ® 994
The primary application area is its use as a release agent for assembly mortars placed between refractory
ladle and tundish components. Typical locations are between the slide gate well block to
inner nozzle, joints between plates and nozzles and changeable nozzles. It is also recommended for
ladle gas purging well block and cone assemblies and the joints between
tundish well blocks and submerged nozzles.
The material hinders the sintering / bonding of ceramic refractory masses to mortars and cements
that are used in conjunction with renewable refractory parts. The removal of all parts is made easier,
quicker, more efficient and with minimum waste. The life of steel plant ladle linings is enhanced
through reduced collateral damage.
MOLY-PAUL ® 994 is also used by steel workers in the ladle "make-up" areas to enhance process
capability and increase refractory life through reduced friction and wear of the refractory plate sliding
surfaces. This product is designed for atomised spray application onto hot surfaces. It is applied
through the collector nozzle/plate bore, or to exposed refractory plate surfaces located in "open"
slide gate valve mechanisms. Both application methods introduce a non-stick neutral refractory
coating to the working I sliding refractory surfaces and offset the problems caused by carbon losses
from the buIk refractory.
MOLY-PAUL ® 994 is a release agent for joint connections and ensures the rapid and trouble-free
replacement of all ceramic parts. It does not accumulate through successive applications to form an
open joint between the ceramic parts and can be applied with a simple hand held, compressed
Air atomizing spray gun.
FUCHS LUBRITECH GMBH Neuenhofstraße 101
- MOLY-PAUL DIVISION - 47055 Duisburg / Germany
phone: +49 (0) 203 578861-0
fax: +49 (0) 203 57886120
e-mail: molypaul@fuchs-lubritech.de
www.kspaul.de
January 2013 Rev. 08 DIN ISO 9001 / EN 29001