Manual Drawing Structural Steelwork - Industrial Centre

More documents

Recommendations

Info

<strong>Drawing</strong>s for connection details The following information are relevant : (a) for bolting (b) for welding • The number and diameter of bolts • Provision of washers • Diameter of bolt holes • Position/spacing of bolt holes • Edge distance to hole • form of weld (e.g. fillet, butt.) • size of weld (leg length) • weld length • spacing of intermittent welds • symbols as recommended by BS 499.
Glossary The following terms may be used in drawing to describe steelworks : • Flange • Web • Web stiffener • Cleat • Bracket • End plate to tube • Base (to stanchion) • Gusset • Splice • Tie (of a truss) • Top chord (of a truss) • Bottom chord (of a truss) • Strut (of a truss) • Countersunk bolt • Shank/thread of bolt • Backing (to contain weld)
Page 1 and 2: Manual Drawing Structural Steelwork
Page 3 and 4: Structural Steel work (BS 449, BS 5
Page 5 and 6: Steel Cross-Section • I - Univers
Page 7 and 8: Columns/Stanchions • Stanchions a
Page 9 and 10: Types of Connections • Bolts •
Page 11 and 12: Basic components (3) • The nomina
Page 13 and 14: Use together with concrete • Stee
Page 15: Drawing for Steelworks layout The f
Page 19 and 20: Typical Connection of Joint
Page 21: 6 mm fillet weld 171 Beam B3 352 20

Manual Drawing Structural Steelwork - Industrial Centre

Create successful ePaper yourself

Delete template?

Save as template?