TRIVAC

Dust Filters
FS 2-4, FS 8-16, FS 30-60
a
a
h
c
DN
c
DN
h 1
h
Dust filter
h 1
The dust filters protect the pumps
against the intake of dust.
b
b b1
Advantages to the User
- Easy to disassemble
- Vacuum-tight cast iron casing
- Replacement filters may be easily
exchanged
- Separates dusts from a grain size of
1 µm
Technical Information
Installing a dust filter in the intake line
of the pump will throttle its pumping
speed at low intake pressures more
than at higher intake pressures. This
must be taken into account when designing
a vacuum system.
Since the dust filters have only a small
dust collecting chamber, we recommend
– in the case of larger dust
quantities – the two-stage dust separators
from the AS range.
FS 2-4, FS 8-16 FS 30-60
Type DN a b l b 1 c h, approx. h 1 , approx.
FS 2-4 16 KF mm 90 112 – 30 105 165
in. 3.54 4.41 – 1.18 4.13 6.50
FS 8-16 25 KF mm 110 150 – 50 125 205
in. 4.33 5.91 – 1.97 4.92 8.07
FS 30-60 40 KF mm 130 190 170 60 225 250
in. 5.12 7.48 6.69 2.36 8.86 9.84
Dimensional drawing for the FS dust filters
Technical Data FS 2-4 FS 8-16 FS 30-60
Connection to pump
Ordering Information
TRIVAC
Throttling of the pumping speed
at 1 mbar (0.75 Torr), approx. %
at 10 mbar (7.5 Torr), approx. %
Weight
kg (lbs)
D 2,5 E
D 4 B D 8 B D 16 B D 25 B D 40 B D 65 B
6 10 12 18 12 25
4 7 6 9 3 8
1.0 (2.2) 1.0 (2.2) 1.6(3.5) 1.6 (3.5) 7.5816.5) 7.516.5)
FS 2-4 FS 8-16 FS 30-60
The dust filters should be installed in a
horizontal flow so that the filter insert
may be removed by pulling it down
and out.
Dust filter
Replacement filter insert
Replacement wadding cartridges
(1 set = 10 pieces)
Part No. 186 05 Part No. 186 10 Part No. 186 15
Part No. 178 32 Part No. 178 33 Part No. 178 35
Part No. Part No. Part No.
200 39 050 200 39 051 971 78 251
Oerlikon Leybold Vacuum Full Line Catalog
51
C01