Mine Safety and Health Administration (MSHA) - Small Mine Office ...

More documents

Recommendations

Info

U.S. Department of Labor Mine Safety and Health Administration MSHA’s Small Mine Office—Serving the small mines in America Location:__________________________Supervisor:___________________________ Date:__________ Time:_____________________ Duration:_________________ 1) D r i l l s Use lubricating oil when drilling large holes Keep drill bits sharp and in good repair Make sure the drill has a ground pin on power cord 2) G r i n d e r s Maintain proper gap between tool rest and grinding wheel (1/8”) Use goggles or face shield when grinding Turn grinder off when not in use 3 ) W e l d i n g A c c e s s o r i e s Keep welding hood and glasses clean and in good working order Always use gloves when welding or cutting Always use an approved striker Attendees: _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ Employees Comments:
U.S. Department of Labor Mine Safety and Health Administration MSHA’s Small Mine Office—Serving the small mines in America Location:__________________________Supervisor:___________________________ Date:__________ Time:_____________________ Duration:_________________ 1) W e l d i n g C o u r t e s y Use screens to shield people from welding arc Collect used “butts” of electrodes for proper disposal Practice good housekeeping and clear area after completing your work 2) O x y g e n – A c e t y l e n e C u t t i n g T o r c h e s Always close the fuel and oxygen valves when not in use Turn off regulators if tank valves have been closed Repair any hose leak immediately and discard those hoses that are in poor condition. Use correct wrenches when installing or removing regulators 3 ) J u m p S t a r t i n g B a t t e r i e s Always use approved jumper cables Correctly connect positive and negative terminals Make the last connection for the dead battery by placing negative cable to engine frame, away from battery to avoid possible explosion Remove all flammable material, including cleaners and solvents, from the area before jumping Attendees: _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ _______________________ ________________________ ______________________ Employees Comments:
Page 1 and 2: U.S. Department of Labor Mine Safet
Page 31: U.S. Department of Labor Mine Safet

Mine Safety and Health Administration (MSHA) - Small Mine Office ...

Create successful ePaper yourself

Delete template?

Save as template?