Orthotics and Prosthetics

More documents

Recommendations

Info

CAST MODIFICATION 1. The proximal section of the cast is modified in the same manner recommended for the conventional PTB down to the mid-leg level (Figs. 17, 18, and 19). 2. Extra relief is given to the medial and lateral malleoli and any other prominences as appropriate. 3. A metatarsal arch is cut into the sole of the foot—located 1/2 in. behind the apices of the metatarsals, the high point being under the second metatarsal and extending into a triangular shape under the shaft of the metatarsals (Fig. 20). 4. The longitudinal arch is defined further (Fig. 21). 5. The cast is then smoothed and prepared for lamination in the conventional manner (Fig. 22). Fig. 17. The negative wrap has been stripped away, and reference lines outlining bony prominences have been reinforced on the crude positive model. Fig. 18. Plaster has been removed in the area of the patellar tendon, under the medial condyle, and along the proximal part of the tibia and fibula.
Fig. 20. Finished plantar surface of positive mold; note formation of metatarsal and longitudinal arches and relief for base of fifth metatarsal. Fig. 19. Plaster of Paris has been added over the head of the fibula, lateral tibial condyle, proximal tibial shaft, and the tibial tubercle. Posteriorly, the popliteal area is built up and flared for the hamstring tendons. Fig. 21. The finished positive mold is ready for the first lamination process: note relief for malleoli.
Page 1 and 2: DECEMBER 1974 Orthotics and Prosthe
Page 3 and 4: Orthotics and Prosthetics EDITOR A.
Page 5 and 6: THE AMERICAN ORTHOTIC AND PROSTHETI
Page 7 and 8: PROSTHETIC SOPPLY CO. 947 JUNIPER S
Page 9 and 10: POST-SURGICAL SUPPLIES ABOVE-KNEE S
Page 12 and 13: Choose it - Because body conditions
Page 14 and 15: CAMP TAYLOR-TYPE ORTHOSES are full
Page 17 and 18: SOME OBSERVATIONS ON UPPER-LIMB PRO
Page 19 and 20: EXPERIENCE WITH PLASTIC PATELLAR-TE
Page 21 and 22: the plastic orthosis is applied snu
Page 23 and 24: earing orthosis was more acceptable
Page 25 and 26: Case No. 4. H.S., a 61-year-old ind
Page 27: other pertinent bony prominences. T
Page 31 and 32: Fig. 23. The positive mold has Fig.
Page 33 and 34: 3. A PVA bag is placed over the cas
Page 35: LITERATURE CITED 1. Corcoran, P. J.
Page 38 and 39: sphere which is held in the mandrel
Page 40 and 41: stress concentrations at the end of
Page 42 and 43: Fig. 8. Prosthesis ready for fittin
Page 45 and 46: DEVELOPMENT OF A THERMOPLASTIC BELO
Page 47 and 48: Fig. 6. Cutaway view of pylon lamin
Page 49: to point out that his own contribut
Page 52 and 53: well as the foot; and a "KAFO" (kne
Page 54 and 55: fresh approach to the problem was m
Page 56 and 57: TABLE II. AMPUTATION LEVELS—LOWER
Page 58 and 59: • That from six to ten prosthetic
Page 60 and 61: ACKNOWLEDGMENTS The Task Force was
Page 63 and 64: A PROPOSED PROSTHETICS TERMINOLOGY
Page 65 and 66: The nature of the distribution will
Page 67 and 68: PROSTHETICS FORM/Upper Limb APPENDI
Page 69 and 70: X-RAYS: A "FITTING TOOL" FOR THE PR
Page 71: Fig. 4. Closed Syme's prosthesis; a
Page 74 and 75: turned. The following information w
Page 76: APPENDIX A COMMITTEE ON PROSTHETICS
Page 80 and 81:
66 NEW PUBLICATIONS THE CARE OF THE
Page 82 and 83:
68 NEW PUBLICATIONS PUBLICATIONS AV
Page 84 and 85:
70 INFORMATION FOR AUTHORS ORTHOTIC
Page 86 and 87:
72 METRIC SYSTEM Conversion Factors
Page 88 and 89:
74 NEW ABC CERTIFIED PRACTITIONERS
Page 90 and 91:
dm CompleteLineOf Components &Supli
Page 92 and 93:
Riaidlv spinal doctors Spinal appli
Page 94 and 95:
Sutton's SJ/4 Jack Sander.. . YOU'L
Page 96 and 97:
Cut it. Mold it. Bend it. Shape it.
Page 98 and 99:
WASHINGTON PROSTHETIC SUPPLIES WHY
Page 100 and 101:
CLASSIFIED ADVERTISEMENTS Advertisi
Page 102:
AMERICAN BOARD FOR CERTIFICATION IN
show all

Orthotics and Prosthetics

Create successful ePaper yourself

Delete template?

Save as template?