Moving Coil Actuators - ORLIN Technologies Ltd

Controllers / Amplifiers
SMAC can supply a range of single and multi axis controllers together with stand alone amplifiers and stepper driven
driver. Controllers are programmed by mnemonic type command instructions via an RS-232 interface into NVRAM.
They require no supplementary software.
LAC-1
Single axis controller, built-in
amplifier
Mode:
• Position
• Velocity or Conti nuous
• Force
8 I/P, 8 O/P TTL general
purpos e I/O’s, RS232
Interface, 3 analog I/P
LAC-25
2 axis c ontroller, built-in amplifier
Modes:
• Position
• Velocity
• Force
• Gearing
Independent or coordinated 2 axis
moti on, 4 I/P, 4 O/P, Opto-isolated
general purpos e I/O’s, 2 analog I/P,
2 analog O/P, RS232 Interface
LAA-5
Single axis amplifier
+/- 10 Volt I/P, 3 Amp O/P
LAD-1
Smart Driver for single axis
stepper I/P to ser vo O/P
RS232 Interfac e
Cables
Controller / Amplifier / Smart Driver
Actuator LAC-1 LAC-25 LAA-5 LAD-1
CAL12 Flying lead
CAL35 CAH-LOD-03 CAH-LAD-03 CAH-LSD-03
CAL75 LAH-LOD26-03 LAH-LAD26-03 LAH-LSD26-03
All cables except fl ying lead are 3m standard, opti onal l engths
from mini mum 1m up to maxi mum 10m.
Superflex availabl e: suitabl e for robotic applications, is available
as an option.
2 x CAL35 CAH-LTD-03
2 x CAL75 CAH-LTD-03
Hardware Configuration
Hardware with SMAC Controllers
Hardware with SMAC Amplifier
7 www.smac-mca.com
Specifications subject to change.