Haltec catalogue - RLM Distributing

INFLATORS
10013 Large Bore
Screw-On Chuck
Fits 3 ⁄8" I.D. air hose.
I-401 Extra Heavy Duty Large Bore
Inflator With Straight Clip-On Chuck
Five-foot Large Bore inflator has 1 ⁄2"
ball valve with provision for checking
air pressure and H-4660A straight
lock-on-chuck. Rubber hose is 5'
long. Inflator has a 3 ⁄8" I.D. for maximum
air flow. Threaded for 1 ⁄2" male
NPT hose fittings.
SAFETY PRECAUTION
These products, as well as all tire tools, should never
be used by persons unless they have been trained
properly according to O.S.H.A. Regulation #29CFR
1910.177 entitled "Servicing Single-Piece & Multi-
Piece Rim Wheels."
I-402 Series Safety Inflator
Available in 3' and 6'
lengths. has pressure check
valve for exact pressure
check with your pencil
gauge. Has manual bleed
valve for adjusting tire pressure
and CH-360-OP flow
through clip-on air chuck.
I-400 Large Bore Inflator
Same as I-401 above except with
10013 Large Bore screw-on chuck.
Fits 3 ⁄8" I.D. air hose.
I-404 Heavy-Duty Dual Hose
Inflator
Heavy-duty inflator has two separate
clip-on chucks with five-foot
hoses. One chuck, CH-360, fits
Standard Bore valves and the
other, H-4660A, Large Bore valves.
Has spring-loaded, hand-operated
valve and has provisions for
checking air pressure during
inflation. Threaded for 1 ⁄4" male
NPT hose fittings.
I-409 Large Bore Inflation Gauge
Large Bore inflation unit
with in-line gauge. Equipped
with H-4660A chuck and a
6' hose. Gauge is calibrated
10-120 psi in 2 lb. increments.
I-408 Dual Tire Inflator Gauge
Has five-foot hose to a tee connection, 2' of hose on each side
with 12" sliding sleeve, lock-on chuck for easy access to inner
dual and dual foot lock-on chuck for outer dual tire. Allows
user to engage and disengage chuck quickly. As the same air
source serves the unit, both tires are automatically inflated
equally. Lock-on chuck fits any standard truck valve stem or
the DS-1 double seal cap.
45