XRAY T2 009 EU Lipo Conversion Set

RUBBER - SPEC LIPO CONVERSION SET
Because of enormous increase in Lipo batteries popularity, XRAY is the first car which is introducing Lipo
conversion set. Thanks to the conversion, both EU and US edition cars can be powered by the most used and
popular Lipo batteries.
Do not use the standard rear
top deck from the kit.
3x6
(from kit)
3x8
3x8
301183
(from kit)
301186
301186
NOTE! The LiPo Conversion Set allows for the fitting of popular LiPo battery packs with a height of 24.5mm or
less (the most popular and common configuration and sizing available on the market at the time of development).
However, because of continuing development of LiPo batteries and no set of standardized regulations about battery
sizes, XRAY cannot guarantee that all LiPo battery packs will fit in the EU Edition cars using this conversion set.

LiPo Battery Fitting
Because LiPo batteries are also different in the width, it is important
to correct the length of ESC wiring so that the battery connectors can
easily be connected to the batteries. If the battery connectors cannot
be connected because the top deck is in the way, please follow the
modification shown in the pictures.
CUT
SOLDER
Fibre Tape
(HUDY #107870)
Pinion Assembly
Because of the LiPo battery width, it is important
to check that the motor pinion is not touching the
battery. If the pinion touches the battery (or is close
to touching it), move the pinion closer to the motor.
It is sufficient to have only half of the pinion teeth
contacting the spur gear teeth. This has no effect on
the car’s speed or performance.
min. 1mm