RC PLANE WITH SLATS AND FLAPS AEROMODELLING CLUB IIT ...

More documents

Recommendations

Info

WE JOINT TWO ROUND STYROFORM AT EITHER ENDS OF THE WING TO GIVE IT PROPER SHAPE AND USED TAPES TO GIVE IT STRENGTH. WE COVERED THE PLANE BY PLASTIC COVER. 2.SLATS : # WE MADE SLATS BY USING STYROFORM AND USED TAPING TO GIVE IT STENGTH. IT WAS A FREE HAND SHAPING BY SAND PAPER. # THE SHAPE OF THE SLATS ACCORDING TO MEASUREMENTS OF AIRFOIL.
SLAT MECHANISM: WE USED A SMALL PIECE OF PLYWOOD AND HINGED IT TO THE LEADING EDGE OF WING THROUGH CLIPS SO THAT IT CAN MOVE INDEPENDENT OF OTHER PART OF WING. WE ATTACHED THIS ROD TO A SERVO SO THAT IT CAN CONTROL ITS MOVEMENT .
Page 1 and 2: RC PLANE WITH SLATS AND FLAPS SCIEN
Page 3: WE CONNECTED ALL AIRFOILS THROUGH C
Page 7 and 8: 2. SLATS ALSO HELP IN DELAYING FLOW
Page 9: 2. EXTENDED FLAPS INCREASE THE DRAG
Page 12 and 13: HORIZONTAL AND VERTICAL STABILIZERS
Page 14 and 15: SERVOS: WE USED 6 SERVOS IN THIS PL
Page 16: SOURCES OF INFORMATION: *GOOGLE *RC

RC PLANE WITH SLATS AND FLAPS AEROMODELLING CLUB IIT ...

Create successful ePaper yourself

Delete template?

Save as template?