03Lathe-Part 1.pdf

More documents

Recommendations

Info

Cross Slide • This is the part that moves when facing cuts are made with power feed. • Is also used to set the depth of cut when turning. • The cross slide can be moved by its hand wheel or by power feed. Dr. Amr Shehata Fayed Lathe – Page 42
Compound Rest • The compound rest is fitted on the top of the cross‐slide, is used to support the cutting tool. • It can be swiveled to any angle for taper turning operations and is moved manually. Compound rest • It can be moved in and out by its hand wheel for facing or for setting the depth of cut. Dr. Amr Shehata Fayed Lathe – Page 43
Page 2 and 3: What is the lathe? • Lathe is a m
Page 4 and 5: Types of Lathe Automatic Lathe A la
Page 6 and 7: Engine lathes • The modern engine
Page 8 and 9: Turret Lathes • Semi‐automatic.
Page 10 and 11: Numerical Control Lathe and Turret
Page 12 and 13: Block Diagram of Standard Engine La
Page 14 and 15: Lathe Machine spindle chuck tool-po
Page 16 and 17: Lathe Basics Dr. Amr Shehata Fayed
Page 18 and 19: Lathe Basics Bedways Dr. Amr Shehat
Page 20 and 21: Lathe Basics Tailstock Dr. Amr Sheh
Page 22 and 23: Headstock • The headstock is the
Page 24 and 25: Headstock Nose of the head stock, w
Page 26 and 27: • The ways of the lathe are the f
Page 28 and 29: Tailstock • For drilling use a dr
Page 30 and 31: Lathe Carriage and Apron Dr. Amr Sh
Page 32 and 33: Carriage Feed • Longitudinal Feed
Page 34 and 35: Apron Hand Wheel Apron Hand Wheel T
Page 36 and 37: Power Feed Clutch Engages the power
Page 38 and 39: Carriage Parts • Carriage consist
Page 40 and 41: Saddle Dr. Amr Shehata Fayed Lathe
Page 44: Compound Rest • It can also be ro

03Lathe-Part 1.pdf

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?