Exhaust Install - STaSIS

More documents

Recommendations

Info

18 Support the downpipe during installation of the center section of the exhaust to minimize stress on the flex joint. 19 Install the center section using the supplied hardware and gasket. Page 8 of 10
20 Install the driver’s side muffler. Attach the exhaust hanger previously removed from the stock exhaust onto the left muffler. Slide one of the supplied exhaust clamps on before installation. Orient the clamp nut to be outboard. Tighten the clamp just enough so you can still adjust the pipe. (Apply anti seize to all assembly bolts to allow for ease of removal) 21 Install the short intermediate pipe with exhaust clamp onto the center section. Orient the clamp nut outboard. Install the supplied exhaust hanger on the right side muffler. Install the muffler and exhaust clamp with the clamp nut oriented towards the front of the vehicle. Tighten the clamps just enough so you can still adjust the pipes. Page 9 of 10
Page 1 and 2: STāSIS Engineering B8 2.0T Exhaust
Page 3 and 4: 3 Remove the 13mm bolt holding the
Page 5 and 6: 9 Remove the 3 13mm nuts holding th
Page 7: 15 Install the supplied heat shield

Exhaust Install - STaSIS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?