Operator Manual - Cummins Onan
Operator Manual - Cummins Onan
Operator Manual - Cummins Onan
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Brightness and Contrast<br />
From SCREEN, Fig. 2-3<br />
Press SCREEN on any GEN STATUS screen.<br />
Press NEXT on the SCREEN ADJUST screen to select<br />
Brightness or Contrast (Figure 2-7). Press the<br />
right or left arrow to increase or decrease brightness<br />
or contrast.<br />
Note: “Contrast” applies only to the LCD screen.<br />
Press the BACK button to save the settings and get<br />
back to GEN STATUS.<br />
FIGURE 2-7. SCREEN BRIGHTNESS & CONTRAST<br />
Display Setup<br />
Press SETUP on any GEN STATUS screen. Press<br />
the up or down arrow on the SETUP screen to select<br />
DISPLAY SETUP and press ENTER (Figure 2-8).<br />
From SETUP, Fig. 2-3<br />
To select the units of measure for the GEN STATUS<br />
screens, press NEXT on the DISPLAY SETUP<br />
screen to select Units and then the up or down arrow<br />
to select “SAE” or “Metric”. Press BACK to save<br />
the selection and get back to GEN STATUS.<br />
To calibrate the Digital Display Voltmeter, press<br />
NEXT on the DISPLAY SETUP screen to select AC<br />
Voltmeter Calibration and then press the up or<br />
down arrow to increase or decrease the voltage<br />
displayed so that it matches that of an accurate AC<br />
voltmeter (line-to-line or line-to-neutral, as desired).<br />
Press BACK to save the selection and get back to<br />
GEN STATUS.<br />
Note: This procedure does not change AC output<br />
voltage. Have a trained and experienced person adjust<br />
AC output voltage, if necessary, before calibrating<br />
the Digital Display Voltmeter.<br />
Generator Set and Display Information<br />
Press SETUP on any GEN STATUS screen. Press<br />
the up or down arrow on the SETUP screen to select<br />
GENSET INFO or DISPLAY INFO and press EN-<br />
TER (Figure 2-8). This information may be requested<br />
by the service technician. Keep pressing<br />
BACK to get back to GEN STATUS.<br />
FIGURE 2-8. SETUP, GENSET & DISPLAY INFO<br />
2-7