Power Stone Manual - Call Activated AC Power Controler for Your ...

Safety Tip: If you use an extension cord,
be sure it is capable of safely carrying the
current required by your load.
Connecting To The Phone Line - You will find, on the left side of the Power Stone (as
you look at the face of the unit), a 2 port RJ-11 telephone line receptacle. One port is labeled
“LINE”. Take the supplied modular telephone line cord and plug one end into the “LINE”
port. Plug the other end into the telephone wall jack. The Power Stone is now connected to
the phone line.
The other port labeled
“DEVICE” allows you to
connect any “telephone”
equipment (fax machine,
modem, PC fax/modem card,
telephone, answering
machine, etc.) through The
Power Stone to the phone
line. When an inbound call “rings” in to your location, The Power Stone will pass the ring
voltage through to the equipment connected to the port labeled “DEVICE”. When vou are
readv to program The Power Stone on site. vou will be required to plug a touchtone phone
into the port labeled “DEVICE”.
NOW That You're Comfortable! Hopefully you’ve now gotten the basic grasp of how
The Power Stone operates. If not, please browse through this section again. If you know or
think you have a good idea about your application and how The Power Stone needs to be
programmed - go for it! If you have no idea, or just want to get some quick input, please read .
the next section appropriately titled: