Epoxy 17M ABC - Tambour Paints

More documents

Recommendations

Info

(sq m/liter) Drying time** Hard coat drying time** Touch dry**: 4 hours For holding or manual conveyance**: 24 hrs. Dry to recoat Waiting time between coats: For epoxy or polyurethane thinned with water: at least 6, no more than 7 days For topcoat thinned with organic thinner: at least 24 hrs. For Dual Component Paint Mixing ratio by volume A:B – 4:1 Waiting time before painting** Shelf life after mixing Shelf life** 30 min. 4 hrs. 24 months Surface and paint preparation Remove laitance, and loose particles to achieve a stable surface. Surface must have cured for at least 14 days. Primer: Aquapoxy 17M ABC thinned with 20% water or Aquapoxy 15M to a 30-micron thickness (~4-7 sq m/liter, depending on penetration). Continue by painting 1-2 coats of Aquapoxy 17M ABC. For applying to existing acrylic paint: Make sure surface is free of dust, dirt, grease and any loose particles. Gentle abrasion of existing paint using fine sandpaper is recommended. Apply primer coat of binding Aquapoxy M15 thinned 10-15%. Walls, concrete floors in residential parking garages (medium traffic) and stable plaster: Mechanical roughening and removal of all loose particles, laitance and impurities until the original, stable concrete surface is exposed. Apply primer of binding Aquapoxy M15 thinned 10-15% at quantities of 4-5 sq m/liter, depending on penetration. Paint application method Paint method Brush/ roller Regular spraying Airless spraying Atmospheric pressure Nozzle diameter Thinner Thinning percentage by volume Water 5-10% 3 Water 10-25% 3-4 15-21” OR 0.015- 0.021 inch Water 5% Produced by Tambour, Authorized by the Israeli Institute of Standards, complying with ISO 9001 www.tambourpaints.com February 28, 2012 Page | 2
Cleaning thinner Water Application remarks Stir well before and during use. Part B should be well stirred into Part A before thinning. Drying rate depends greatly on temperature and relative humidity. Use only in well-ventilated areas. Safety measures The use of this product and its application must be in accordance with the applicable safety, health and environmental regulations in force in Israel. Please read the safety precautions and warnings appearing in the Safety Data Sheet, available at Tambour’s Safety Department, tel. +972-4-987-7483 as well as on the product label. Keep away from fire and sparks. Do not ingest. Keep working area well ventilated. While spraying do not inhale the fumes. Use proper protective gear; see Safety Data Sheet. General comments The data presented herein are based on the knowledge and experience acquired over many years. We reserve the right to update and/or alter the data without prior notice. Achieving the best results depends on the proper application of the product and on the strict compliance with our instructions and safety measures. Before application, the user should verify that the product is designed for the intended usage and that the surfaces to be painted are properly prepared and suitable for the product’s application. For additional information, please contact our Technical Service Department. * The practical spreading rate may vary depending on the surface, the application mode, the painter’s skills, and weather conditions at the site. Assume approximately 75% of the calculated spreading rate. ** At 25°C and 65% relative humidity Produced by Tambour, Authorized by the Israeli Institute of Standards, complying with ISO 9001 www.tambourpaints.com February 28, 2012 Page | 3
Page 1: Epoxy 17M ABC Antibacterial coating

Epoxy 17M ABC - Tambour Paints

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?