Rosemount Temperature Sensors and Accessories - Transcat

Sensors and Accessories (English)
Product Data Sheet
00813-0100-2654, Rev GB
April 2010
TABLE 4. Series 68 RTD Sensor Assemblies WITHOUT Thermowell
★ The Standard offering represents the most common options. The starred options (★) should be selected for best delivery.
__The Expanded offering is subject to additional delivery lead time.
Assemble to Options
Standard
Standard
XA (9) Assemble connection head or transmitter to a sensor assembly ★
(1) Capsule style available in 1-in. increments only, starting at 1-in. (i.e. 1, 2, 3-inches, etc.) See “Mounting Adapters for Series 58, 68, 78, and 183” on page 66.
(2) This option must be used with Sensor Lead Wire Termination code N and is not available with assembly code XA or with Approval codes E1, E5, E6, and E7.
(3) General-purpose sensors are only available in (L) lengths of 2.5-in. or greater.
(4) Spring loaded sensors must be installed in a thermowell assembly to meet the requirements of explosion-proof approvals code E6.
(5) Not available with Sensor Lead Wire Termination codes R, P, or C or with approval codes E1, E5, E6, or E7.
(6) 1-in. length without extension is only available in capsule style.
(7) SAA Flame-proof Approval is only applicable if installed with Rosemount 248, 644, or 3144P transmitters.
(8) These options are not available with Sensor Lead Wire Termination codes R, P, or W.
(9) If ordering code XA with a transmitter, specify the same option on the transmitter model code.
Ordering Example
Typical
Model
Number
Model
Lead Wire
Termination
Sensor Type
Extension
Type
Extension
Length
Thermowell
Material
Immersion
Length
Additional
Options
0068 N 11 N 00 N 045 E5
16