Can't Connect to 4800 - dbx

On the Driverack 4800:
1. Press the UTILITY button.
2. Turn the # 1 ENCODER until you have selected “Network”.
3. Press the # 1 ENCODER in.
4. Turn the # 1 ENCODER until you have selected “DHCP Enabled”.
5. Turn the # 3 ENCODER until it reads “DHCP Disabled”.
6 . Turn the # 1 ENCODER until the first section of the IP address is highlighted in
blue.
7. You must change the IP address so that it matches your network address. For
example: The network ID in the above Dos window is 10.0 because the subnet
m ask identifies the network ID with the # “255”. The “.1.4” is the computer ID.
Your 4800 should contain different #s for this field (i.e. “.1.5” would work as this
means the 4800 ID is “15”). They can be any # between 1 and 255, but they
should not be the same as any other device on the network.
8. Turn the # 3 ENCODER to change the IP address of the 4800. You can press the
# 3 ENCODER in to toggle between course (red ring) and fine (green ring)
adjustments.
9. Use the # 1 ENCODER to select the different sections.
10. Change the subnet mask in the 4800 to match the computers subnet mask
(in the above example it is 255.255.0.0).
11. Once you have changed the IP address and subnet mask, press and hold
the STORE button until the prompt appears and then disappears.
Note: You may have to wait a moment for the 4800 to change the IP address. Just
wait a moment then press and hold the STORE button (multiple times if needed) until
you see the prompt.
Page 3