list of amendments - ncc 2012 - Australian Building Codes Board

More documents

Recommendations

Info

Page 8 Australian Building Codes Board Reference J6.3(d)(ii)(A) Changes and Commentary Clarification has been added that a security key card reader must register a person entering and leaving the building. J8.1 The application of part has been amended to exempt a Class 8 electricity network substation from compliance with the requirements of Part J8. Specification J5.4 Table 2a Australian Capital Territory Footnote New South Wales Appendix NSW A1.1 NSW Specification A1.1 NSW Table 1 NSW C1.10 NSW J(A)1.1(b) Footnote Queensland Appendix Qld Part G5 South Australian Appendix SA A1.1 SA Table 1 SA A2.2 SA C1.1 Note 2 has been amended to cover applications where local clearances adjoining plant do not allow for the installation of insulation. The Footnote listing other legislation has been updated. The defined term ‘special fire protection purpose’ has been amended to incorporate changes to the State Environmental Planning Policy No 5 and No 9. Reference to NSW legislation have been updated. A number of amendments have occurred to the variation including: • Sub-clause (b) has been amended to refer to specific materials listed in NSW Table 4 of NSW Specification C1.10. • A material in a Class 9b building used as an entertainment venue that is regulated under NSW Table 4 has been included under (c)(xiii)(A) as a material to which the exemption does not apply. Sub-clause (b) has been deleted. As a consequence, amendments have been made to sub-clause (c) and the remaining sub-clauses have been renumbered. The Footnote listing other legislation has been updated. A new Qld Part G5 has been inserted. The following definitions have been inserted or amended: Brush fence As a consequence of a number of South Australian variations being included, a new defined term has been inserted. Renewable A new defined term 'Small-scale Technology Certificate' has Energy Certificate been included as a consequence of changes to the Australian Government's Renewable Energy Target scheme and the removal of the defined term 'Renewable Energy Certificate'. The following references have been inserted or amended: SA A2.2 Reference to SA A2.2 South Australian Minister's Specification — Structural Engineering Software Protocol has been deleted as it is no longer referenced. SA F1.7 The South Australian Minister’s Specification — Waterproofing of wet areas in buildings has been updated to the 2012 version. The South Australian variation has been deleted as a consequence of the adoption of the ABCB Protocol for Structural Software. A new variation has been included to require separation of a Class 2 building from a Class 10b brush fence.
Reference SA C2.15 SA F1.7 SA F1.11 Changes and Commentary Australian Building Codes Board Page 9 A new variation has been included to require separation of a Class 2 building from a Class 10b brush fence. As a consequence of the amendments to F1.7, the South Australian variation has been amended. As a consequence of the amendments to F1.7, the South Australian variation has been amended. SA G5.2 Sub-clauses (d) and (e) have been amended to align with changes from Amdt 3 of AS 3959. SA G5.3 SA Table G1.5 SA J1.3(c) SA J7.5 Footnote Tasmanian Appendix Tas Table 1 A number of amendments have occurred to the South Australian variation as a consequence of aligning the provisions with Amdt 3 of AS 3959. The changes include the following: • An amendment to (d) to include clarification of bushfire-resisting timber. • An amendment to (f) to remove the reference to doors. • A new variation has been included as sub-clause (g). The provision allows the use of polycarbonate roof sheeting for Class 10a buildings located within 6 m of a Class 2 and 3 building for BAL – Low, BAL – 12.5, BAL – 19 and BAL – 29 sites. A number of amendments have occurred to the table as a consequence of aligning the table with Amdt 3 of AS 3959. A new sub-clause has been included for Class 5 to 9 buildings, in certain applications, to have an upper surface solar absorptance value for the roof material of not more than 0.4. As a consequence of changes to the Australian Government's Renewable Energy Target scheme the defined term ‘Renewable Energy Certificate’ has been deleted and replaced by a new defined term ‘Small-scale Technology Certificate’. The Footnote listing other legislation has been updated. The following references have been inserted: Child Care Act (Tas) Education and Care Services National Law Act (Tas) Reference inserted as a consequence of aligning Volume One with the National Quality Framework for early childhood education and care. Reference inserted as a consequence of aligning Volume One with the National Quality Framework for early childhood education and care. Health Services Reference inserted for the purposes of defining health Establishment Act services establishments at Part H109. (Tas) Early Childhood Centre and School Age Care Facilities Code Health Services Establishment Code The 2012 edition has been inserted as consequence of aligning Volume One with the National Quality Framework for early childhood education and care. The 2012 edition has been inserted for the purposes of regulating the design, construction and maintenance of the health services establishments.
Page 1 and 2: Australian Building Codes Board Pag
Page 3 and 4: Australian Building Codes Board Pag
Page 5 and 6: Reference Section E E1.3(b)(i) E1.4
Page 7: Reference GP1.5 Changes and Comment
Page 11 and 12: Reference Tas G5.4(a)(i) Tas Sectio

list of amendments - ncc 2012 - Australian Building Codes Board

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?