FIBRE CHANNEL - T11

More documents

Recommendations

Info

TR-xx-1998 Fibre Channel Tape Rev 1.07 August 7, 1998 2 Normative references The following standards contain provisions which, through reference in the text, constitute provisions of this document. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this document are encouraged to investigate the possibility of applying the most recent editions of the standards listed below. Copies of the following documents can be obtained from ANSI: Approved ANSI standards, approved and draft international standards (ISO, IEC, CEN/CENELEC), and approved foreign standards (including BSI, JIS, and DIN). For further information, contact ANSI Customer Service Department at 212-642-4900 (phone), 212-302-1286 (fax). Additional availability contact information is provided below as needed. 2.1 Approved references [1] ANSI X3.230-1994, Information technology Fibre channel physical and signaling interface (FC- PH) including ANSI X3.230-1994/AM-1-1996 ammendment. [2] ANSI X3.269-1996, Information technology Fibre channel protocol for SCSI (FCP) [3] ANSI X3.272-1996, Information technology Fibre channel arbitrated loop (FC-AL) [4] ANSI X3.270-1996, Information technology SCSI-3 architecture model (SAM) [5] ANSI X3.297-1996, Fibre Channel - Physical and Signalling Interface-2 (FC-PH-2), X3T11/Project 901D/Rev 7.4 2.2 References under development At the time of publication, the following referenced standards were still under development. For information about obtaining copies of the following documents or for more information on the current status of these documents, contact NCITS at http://www.ncits.org or 202-626-5738. [6] ANSI X3.xxx-199x, SCSI-3 Primary Commands (SPC), X3T10/995D/Rev 11a [7] ANSI X3.xxx-199x, SCSI-3 Block Commands (SBC), X3T10/996D/Rev 8b [8] ANSI X3.xxx-199x, Fibre Channel - Physical and Signalling Interface-3 (FC-PH-3), X3T11/Project1119D/Rev 9.0 [9] ANSI X3.xxx-199x, SCSI-3 Stream Device Command Set (SSC), X3T10/Project 997D/Rev x [10] ANSI X3.xxx-199x, SCSI-3 Media Changer Command Set (SMC), X3T10/Project 999D/Rev 10a [11] ANSI X3.xxx-199x, SCSI Fibre Channel Protocol-2, X3T10/Project 1144D/Rev x [12] ANSI X3.xxx-199x, Fibre Channel - Private Loop Direct Attach (FC-PLDA), T11/Project 1162- DT/Rev 2.1 [13] ANSI TR.xx-199x, Fibre Channel - Fabric Loop Attach (FC-FLA), T11/Project xxxx-xx/Rev 2.7 [14] ANSI X3.xxx-199x, SCSI Architecture Model - 2 (SAM-2), T10/Project 1157-D Rev x 2
TR-xx-1998 Fibre Channel Tape Rev 1.07 August 7, 1998 [15] ANSI X3.272-199x, Fibre Channel - Arbitrated Loop (FC-AL-2), T11/Project 1133D Rev x.x 2.3 Other references [16] FCSI Common FC-PH Feature Sets Used in Multiple Profiles, Rev 3.1 [17] FCSI SCSI Profile, Rev 2.2 [18] SFF-8045 Specification for 40-pin SCA-2 Connector w/Parallel Selection, Rev 3.3 3
Page 1 and 2: Copies of this document may be purc
Page 3 and 4: Editor’s Note: Release 1.07 Chang
Page 5: NCITS T11 Technical Report Series T
Page 8 and 9: NCITS TR-xx Fibre Channel Tape Rev
Page 20 and 21: TR-xx-1998 Fibre Channel Tape Rev 1
Page 26 and 27: FC-Tape Fibre Channel Tape Rev 1.07
Page 68 and 69:
FC-Tape Fibre Channel Tape Rev 1.07
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
NCITS TR-xx Fibre Channel Tape Rev
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
RNC 22 RRQ 22 RSI 22 RSS 22 TPRLO 2
Page 110 and 111:
Resets Abort Task Set 56 ABTS 56 Cl
show all

FIBRE CHANNEL - T11

Create successful ePaper yourself

Delete template?

Save as template?